how to program a P5 key fob?

ahh crap. if you do a search its on here some where

its something like turn the key forward like 3 time then hold the door light switch and press thenat theen hit lock and unlock. wait 1 minute
 
hahaha foudn it in an email

Step 1: Open [COLOR=green! important][FONT=verdana, arial, sans-serif][COLOR=green! important][FONT=verdana, arial, sans-serif]drivers [/FONT][COLOR=green! important][FONT=verdana, arial, sans-serif]door[/FONT][/COLOR][/FONT][/COLOR][/COLOR] and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the
[COLOR=green! important][FONT=verdana, arial, sans-serif][COLOR=green! important][FONT=verdana, arial, sans-serif]car[/FONT][/FONT][/COLOR][/COLOR] doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of
[COLOR=green! important][FONT=verdana, arial, sans-serif][COLOR=green! important][FONT=verdana, arial, sans-serif]door [/FONT][COLOR=green! important][FONT=verdana, arial, sans-serif]locks[/FONT][/COLOR][/FONT][/COLOR][/COLOR] and unlocks. You're done!
 
Have a nice chart to make our life easier -
keyless.jpg


have a fun
 
Back