Hatch trim removal

Anybody know how to remove the trim piece around the rear hatch handle ? There are 2 bolts on either side of the handle, but it still is attached pretty good on the ends. Don't know if there are bolts from the inside or just clips but I don't wanna break it.

http://i94.photobucket.com/albums/l97/yaggie1/rear valence/S7300193.jpg

Ya know, just had that panel off changing out a badge, saw the 2 on the outside you spoke of but never looked up in the inside to see for sure but think there was a support bracket for the wiper motor that may have been why I didn't check it much since that wasn't the goal at the time. Lemme check my manual....................REAR FINISHER REMOVAL/INSTALLATION

1. Remove the nuts.
2. Pull the rear finisher toward you, then disengage
clip A from the body.
3. Install in the reverse order of removal.