ABS and brake lights on after brake pad replaced

BIGCU

Member
:
03 MSP
a while ago my ABS and brake light came on and this has happened before but that was due to my front brakes needed changing. so i changed the rear brakes but they're still on... any ideas whats wrong with them?
 
maybe try bleeding the brakes or adding more fluid. just a guess. lol, did you say your front brakes needed to be changed so you replaced the rear brakes or changing both didn't solve the problem? I wish I had more to offer. good luck
 
You may have unplugged one of the ABS sensor wires also.

Brit
 
story is.. on a road trip one time the ABS and brake light came on... we saw the front pads were a little thin so i changed those. The light went off. months later it came on again and i heard squealing from the rears. I changed those but the brake lights has yet to turn off.

Thanks i'll double check the bake fluid see if its low.
 
If you have recently changed your pads you should check your fluid level. It will most likely be too high because at some point I hope you topped it off once it started getting low (because the pads were getting low).
 
has the right amount.
where are the abs sensors?
are they on all 4 wheels?

really wanna get this fixed before the snow starts settling in
thanks guys in advance
 
Back