anyone running this with the maf relocated?
Yeah, I run damn rich at WOT too. I haven't tuned it sepcifically for my car yet. Will do soon. I'm wondering if something else is up with my car because others have said that relocated MAF leaned them out some.byohndspeed said:anyone running this with the maf relocated?
Fudgie said:I ran all 3 maps in my car today to get some wb readings. My mods are smic, 2.5 s-pipe back, stock boost (7-7.5 psi). They all shared the same highs and lows. A little lean going into boost, fat in the midrange (2400-4000 rpm) leaning out between 4-4500 and then back to a richer mixture up until she coughs. W/ the stock supermap in 3rd gear wfo it ran in the 10.5-10.8 until 4k, 4-4.5k: 12.2-12.6 and then back down to 10.2-10.5 until redline. W/ the fmic maps: 9-9.2 until 4k, 10-10.2 until 4500 and then back into the 9's until redline. Jeffs winter map was as expected, a little more rich. So for me, the stock supermap is a better baseline (obviously). The temp here was about 25 degrees f when I took these readings. Figured I'd post them for the hell of it. When I get done modifying my map I'll post it up.
kicker22705 said:i have a 440cc @ 14psi map i would like to share but, its running crappy afr.
its running 9.5 then 10afr towards redline.
i tried roadtuning it last nite to get better afr so i can share a better map but it seems no matter how much fuel i pull it keeps running 9.5-10afr. i'm shooting for 11s dropping to 10 towards redline.
i'm gonna give it a try again tonite and tomorrow night, and if it still doesn't work i'll post what i have now.
if anyone has any suggestions please chime in.
That is the way I would do it too. Have you tried to reset the ecu? I don't think you have to do it everytime you change your tune but since is not working you might want to try.kicker22705 said:im using my wb to roadtune it.
the exact procedure we follow is
1. Edit Fuel Map
2. Key turned to ignition on (motor turned off)
3. Write edited map to ECU
4. Once Writing to ECU is completed, we turn on the car and go for a drive.
i pulled fuel from 8.8 to 8.6, 8.2, 7.8, down to 7.2 w/ no changes to the afr @ 14-15psi.
Blue_Speed said:I'm wondering if any1 could tell me if adding a MIL eliminator will affect the ecu, because i know there is one wire that plugs into the stock o2 sensor.
Also kicker22705, do you know if there is a way we can datalog our wideband to the afc recordings. i see that me and you have the same wbo2 and it makes it a little complicated cause you cant datalog the afc and wbo2. i emailed dsm and AirFlowTech to see if there is anything i can do but havent received any replies yet.