What have you done to your P5 today?

Since we’re doing milestone photos, here’s my daughter’s new MSP. We did a car swap (funny swapping a titanium MSP for a titanium MSP) and as I was getting ready to drive away she tells me “Im so close to 200 - just get a picture for me”

IMG_7586.jpeg
 
Interesting. They may have been machined to fit. I've heard of people on here doing that for Lexus wheels. I've seen a few Proteges online with the STI BBS wheels so people must be willing to go through the hassle. If it were me, I'd go the Mitsubishi route, as the Evo Enkei wheels I believe do have the same bore and do come in some good sizes for the Protege.
Can confirm that Evo OZ / Enkei wheels do fit very nicely with a slight guard roll on the rear, especially if lowered. Bore is the same, Evo 5 (silver) wheels require square shouldered wheel nuts and washers.

Both photos at stock ride height, 17" versions of both wheels
20180908_135825S.jpg

20190209_151409.jpg
 
Changed out the passenger motor mount on my daughter’s MSP. It’s the 3rd Protege I’ve done this job on. Took about 15mins while taking pictures and cleaning as I went. The passenger mount alone was $42 and a full kit was $51 on Amazon. Make sure you get the kit where the passenger mount already had the “dog bone” pressed in.

HERE IS THE IMPORTANT PART:
This car has a really good transaxle; no grinds and quiet. I noticed that sometimes there is a very mild “hitch” where it doesn’t want to move cleanly into 2nd on the 1-2 shift. Like if you are lazy and don’t pay attention, you will grind the syncro. BUT, after replacing this mount and also having front /rear AWR mounts, the engagement is much more positive and clean. I surmise that a large reason the trans in our cars have problems is less the trans and more the movement of the
 
Changed out the passenger motor mount on my daughter’s MSP. It’s the 3rd Protege I’ve done this job on. Took about 15mins while taking pictures and cleaning as I went. The passenger mount alone was $42 and a full kit was $51 on Amazon. Make sure you get the kit where the passenger mount already had the “dog bone” pressed in.

HERE IS THE IMPORTANT PART:
This car has a really good transaxle; no grinds and quiet. I noticed that sometimes there is a very mild “hitch” where it doesn’t want to move cleanly into 2nd on the 1-2 shift. Like if you are lazy and don’t pay attention, you will grind the syncro. BUT, after replacing this mount and also having front /rear AWR mounts, the engagement is much more positive and clean. I surmise that a large reason the trans in our cars have problems is less the trans and more the movement of the
I've noticed the exact same thing with the 1-2 shift, and I think my 2nd gear syncro is starting to wear out from occasionally grinding 2nd like that.

My worst gripe with my P5 is those mounts. I've never been able to find a good balance between reasonable NVH and smooth shifts and smoothness on/off throttle. Drives me nuts, but not going to throw any more money at it.
 
I've noticed the exact same thing with the 1-2 shift, and I think my 2nd gear syncro is starting to wear out from occasionally grinding 2nd like that.

My worst gripe with my P5 is those mounts. I've never been able to find a good balance between reasonable NVH and smooth shifts and smoothness on/off throttle. Drives me nuts, but not going to throw any more money at it.
I've had good luck by replacing three of my four mounts so far with OEM ones, but they were spendy. While I drive spiritedly, I don't shift anywhere near aggressively, so maybe my needs are less.
 
Had a curious sound pop up after doing spark plugs, wires, and boots (not coils). Sounds like the lifter tick from my Miata, but some think it's a rod or bottom end.

Can you drive with the engine knocking?
What symptoms happen while driving with a bent rod?
Does the sound change or stay linear?
 
Chasing down a sluggish transmission from a cold start, I decided to change out the solenoids.
So here's my part list and costs and it drives like it's off the lot!

03/29/24 - Transmission Tune Up ($518m + $225l) = $743
IDEMITSU 30040092750 (M5) ATF Type M; 8 Quart $8 * 8 = $64
ATP B189 (Standard Replacement) Premium Replacement; With 3rd Hand Gasket $16
PIONEER 771111 Transmission D&E Shift Control Solenoid x 2 $45 * 2 = $90
PIONEER 771116 EPC x 1 $78
ROSTRA A48421 PWM x 3 $90 * 3 = $270
That's fantastic news. :) Not really related, but you made me think of this... Way back at 30k miles, I got my manual transmission fluid replaced *at the dealer*. Car immediately had intermittent trouble shifting, most noticeably from 1st to 2nd. I turned the car around and went back to the dealer, who replaced the fluid again. The car displayed the same behavior, and I just dealt with it for 30k miles, hoping it would break in. It never did, and it was a safety concern that entire time. I went to a Goodyear place at 60k miles and they replaced it, and the car shifted fine after that. I didn't dare change it again until 130k miles, whereupon I replaced the fluid myself. I've not had a problem with this fluid either. I don't know what the dealer put in there, but it didn't work well.
 
Well folks........fixin to sell the car sooooooooooo, there's a mountain of parts, some new, some never installed, some used, some oem, some aftermarket.....too many to even comprehend much less list. The original owner 100k mile car will be going as is. All this stuff is boxed up in garage and attic. Stuff like brand new MP3 splitter, untouched glo face gauges for auto, tein springs, etc list goes way deep......fuel controller with NA module/flyin miata voltage clamp/innovate wb 02 with gauge......when is the last time you've seen a Perrin fuel rail with liquid filled pressure gauge, header header and header - used and untouched one. So much I cant even think about. new alternator, original struts with about 15k on them, projector headlights, space cadet clear tails, magnaflow muffler....just goes on and on. Someone in TX come get bundle deal......Screw that eclipse, come get shitload of useful parts for whatever form of 99-03 Protege you might has. Emblems from around the world - astina, familia, allegro, genki whatever, south africa one, P5, 323 etc Rent a van pack it full. CRAZY INSANE BUNDLE DEALS
 
When is last time you've seen cabin air filter conversion parts for this car? Yep, got that crazy stuff layin around never done. Blue GT Spec stuff? You bet. 20 yrs of collecting goodies like this, some installed some wasn't yet.....
 
Well folks........fixin to sell the car sooooooooooo, there's a mountain of parts, some new, some never installed, some used, some oem, some aftermarket.....too many to even comprehend much less list. The original owner 100k mile car will be going as is. All this stuff is boxed up in garage and attic. Stuff like brand new MP3 splitter, untouched glo face gauges for auto, tein springs, etc list goes way deep......fuel controller with NA module/flyin miata voltage clamp/innovate wb 02 with gauge......when is the last time you've seen a Perrin fuel rail with liquid filled pressure gauge, header header and header - used and untouched one. So much I cant even think about. new alternator, original struts with about 15k on them, projector headlights, space cadet clear tails, magnaflow muffler....just goes on and on. Someone in TX come get bundle deal......Screw that eclipse, come get shitload of useful parts for whatever form of 99-03 Protege you might has. Emblems from around the world - astina, familia, allegro, genki whatever, south africa one, P5, 323 etc Rent a van pack it full. CRAZY INSANE BUNDLE DEALS
Where in Texas? We're in Houston.
Interested in alternator, muffler, headlights, header,
 
Back