$19.99 JDM Mazda Coilovers yo!

coilovertable.jpg
 
WAhahaha. I completely thought you were kidding.

Is there anyway possible someone could put those on a Protege?? I mean, not thinking about it but... well... no seriously.... I swear... I'M NOT!
 
i cut holes out of the bottom mounting plate (plywood overlayed with diamond plate) and used the set screws that come with the kit to secure them in those holes. I decided later to back this up with some squares of plywood on the bottom of the holes (as well as to raise the base of the table off the ground)

Yes it is height adjustable :D

I test fit these on a spare strut i had laying around and i would say you couldnt pay me to put these on my car. The fit is so loose im sure you would get some mad clunking.
 
Its an easy task.... I just don't have coilovers sitting around. If you can install them in a car.... then you can make a table out of them!
 
Back