Search results

94 MX-6 wheels with Toyo Eclipse 205-50-15 Fits 03 Protege ( I had them on for offseason use) $225 92 MX-6 wheels with Michelin Ice-X snows 195-60-15 $175 good tread on both, save your good rims in the winter with these.

I have a set of 15" Protege rims with Toys Eclipse tires with a lot of rubber left 15" set of MX-6 rims with Ice-x snows 250 for the Protege 200 for the MX-6 with snows Seattle area. Used on my Mazdaspeed that is now gone. Rims do fit the 03 email me if interested

14 inch mesh wheels, one with centers bead blasted for paint 200, 250 for bead blasted set Also, gauge pod, console parts etc Alternators email me for local pickup in Seattle area.

Thanks!

Dealer says the rear tail lights are different than standard Protg models. Anyone verify that? OEM Speed taillights are harder to find used.....

How do I get the stupid front running light bulbs out? These are the ones on the front corners. I can't seem to pull the pull bulb harness and there is very little room in there.

Hey, Thanks! It is now up and running. Also, the new head unit puts out less to the subs than the old unit, so it sounded less thumpy. Ran some adjustments and it works well. Must admit that the stock sub box is not so hot. Rattle rattle rattle....Saving that fix for better weather. Thanks again...

Didn't see your reply before I posted. I have a basic electrical multimeter, so I can check leads. Is the power via sub harness? Dang, wish I had a factory wiring diagram!

bumpity and some more clarity. Got in it again today. From HU: Blue/white (no solid blue from head) Into the Mazda harness Blue/white AND Blue Subwoofer Harness 2 RCA's and one Blue/white Current set up, HU Bl/W direct to Subwoofer Bl/W Factory side of main harness...

OK, interesting. I deadheaded blue, as the JVC and Crutchfield both showed to use blue/white. Should I reconnect the Bl/W from the HU with the Bl/W on the Crutchfield harness? The Crutch folks call Bl/W Amplifier turn on and JVC calls it other equip or active antenna. Hey, and I would love...

OK, I got the unit in, but no subs. Crutchfield said to run the blue lead on the JVC unit directly to the bullet connector on harness from the subs, which has 2 rca's and a bullet connector. Anyone confirm this on an 03 Speed?

I assumed single and double din metal was standard. I soldered up the harness last night, out to install today.

Can my new head unit just go in where the last came out? The original was stolen... Or do I need to pull out the trim around the vents/AC knobs etc? Crutchfield sent a new black bracket to seat the head unit in. Necessary? The main reason to pull the trim would be to better access the...

Use some 15" MX-6 rims. You will have just enough caliper clearance, and the cost of the snow tires drops dramatically at 15" sizing, nor will potholes ding your rims.

I can see the main harness, but not the rca. Looks like they pulled the stuff past the harness clip, but I can't see the rca jack down there. I may have to get under the dash and look from below. Crap.

Our stereo got ripped off in the 03 speed. I can't see well enough to tell if there is a harness and an RF connector. Anyone know?

I'm old and my ass already sags! I am just doing the fronts due to the strut leak on one side. The rears tend to last far longer. I will leave the rear struts in place. Tokico notes that the perches for for Illuminas and HP's are the same however. Did Racing Beat just use standard HP's in the...

Thanks, that is what I have found so far.

Only have 60k on the springs, so they should be ok. Any ideas on how the valving/rates on the OEM Speeds compare to illumina? I have illuminas on an IS300 lexus, and the 3 setting on the front is just fine, but 5 would be rather stiff.

I have a 2003 Speed and have a leaky left front strut. I would rather use illuminas in place of the altered MSP Tokico HP's. Can this be done? Also, can struts like these(HP's) be rehabbed?