Search results

Replaced the cooling fan assembly, which fixed the problem. Upon inspection, the signal wire from the PCM had corroded and broke off of the fan module. This explains why the fan would not come on.

Just do it. ;) Better safe than sorry.

Looks like my cooling fan is not working. I drove around today in the warmer weather and noticed that my coolant temp was higher than normal. When I got home, I tested to see if the fan would go on and the gauge got to about 3/4 of the way up and the fan never turned on. I'm guessing that my...

*2004 Mazda 3 Hatchback, 2.3L, ATX, Standard HVAC Controls It's been getting a tad warmer up here in Michigan lately. Driving the Mazda, I have noticed my A/C is not working very well. I know the A/C in these cars is not exactly the most awesome setup, but I believe that I may have an issue...

Thanks :)

I uploaded my pictures today. http://www.flickr.com/photos/63517706@N05/sets/72157626732002177/

I had a fantastic time!

See ya there! I will be showing up Saturday.

First thing I did was independent fog lights.

Detroit, MI

Oil Change today in the nice Feb. weather. I should be good for a while.

My Mazda 3 has an automatic transmission, while my Probe was converted to a manual transmission back in 2001.

I tightened an endlink today. No more front end noise. :)

Update, I did finally get everything back together and start driving it last week. Basically, I decided to replace the entire axle since boots are not the easiest thing to find. When I removed the axle I had found that the snap ring on the intermediate shaft had not been reinstalled after the...

After further examination, I checked the motor mounts. They looked to be ok, however I noticed that the passenger axle had been replaced. I also noticed the passenger axle was backing out of the intermediate shaft (almost off at this point). I tried hammering it back in, got it most of the way...

Turns out that it is not flat spotting. I double checked the tire pressure and took it for a drive. Same thing issue. I brought it home and put it up on jack stands. Decided to run the car in gear with the tires off of the ground and the hood up. The vibration was still present and the engine...

Thanks for the input! I'm still getting acquainted with the 3 and it's quirks so I feel like a complete newbie. I was thinking that flat spotting was a possibility as well, so that is probably more probable than the mounts. I've just never experienced flat spotting before(even though I have...

The last week or so, the temperatures have dipped into 30's or colder. Since then, I have noticed a new issue with my Mazda (2004, Mazda 3 Hatchback, Automatic Trans). When I first start driving it, everything seems fine. However, soon after I start driving I notice this terrible vibration...

I am on both. I am pgt4speed on Probetalk. I post there fairly regularly. I am EvilSandon on mx6.com, but rarely post.

Apparently I registered on this site a long time ago, but today was the first time I have bothered to post. I have owned my Probe since 1998, but recently I have picked up a Mazda 3 for my daily. The Probe has a lot of fun stuff done to it such as KLZE Swap, MTX Swap, Suspension, and Wheel...