Search results

Still have the wheels? If so, what are their conditions?

Any interest in separating the vent mount from the boost gauge? I would be only intersted in the vent mount as I already have both the electronic and mechanical versions.

First off, dont use anything but Mazda's FL22 coolant for our engines. I doubt this was the issue. What you should do is a complete coolant flush and thermostat replacement. It will cost total around $80 for the coolant and the thermostat. You can go to any autoparts store and order a...

I would guess that it wouldn't be too hard. Check for an always on wire leading in through the firewall near the clutch pedal and tap into it. Or you could put a wire in from the battery connection. Don't have any ideas for the windows though.

How To: Replacing the front wheel bearings on a Mazdaspeed 6 Replacing the wheel bearings will likely happen around 100,000 miles for our cars. You will know by the sound, the faster you go, the louder it gets. You can confirm that the bearing is bad by jacking up the car and spinning the...

I was planning a How To for this. NAPA Auto has wheel bearings for around $54 each. I recommend replacing both at the same time as they have both seen the same miles and terrain. You will need a breaker bar or decent impact wrench. The wheel nut is size 35mm. You will also need a pitman arm...

Put two stickers on the rear window, cut the RPM down and put corksport below it. Also Brake Pads

Spark plugs changed, arrived at .04-.044". Changed to factory spec of .031". No issues after first test run.

I am wondering if anyone can confirm the gap size for the Mazdaspeed6 NGK Iridium IX LTR71X-11 #6510? What I have seen is .044". Also, will any gaskets need to be replaced with the change of spark plugs?

A friend of mine has had recent issues with his engine upon startup. It would hickup, and sometimes stall out until the engine warmed up a little. He continued driving for like 3 weeks after the first issue. I went over to help and try and trouble shoot. He has a corksport intake and cold...

Just changed these out. While I was at it, I removed the stock airbox resonator (royal pain in the ass). I recommend going from underneath. Shouldnt take more than 10 minutes to replace.

Just remove the inner metal piece, http://www.mazdas247.com/forum/showthread.php?123756514-DDM-6000K-bulb-replacement&p=5028030&highlight=#post5028030

Has anyone tried out the Corksport mud flaps? http://www.corksport.com/corksport-mazda-mud-flap-set.html

Looking for a Corksport Downpipe or mabey open to other downpipes that directly connect with the stock cat.

Went to emissions shop. "Is this thing all wheel drive" <wince>, girl gets in to move it to spinning wheels, stalls. <wtf> Jumps it all over the place while testing, cant do one smooth shift and I constantly hear the whine of the turbo and ping of the BPV <seriously?>. Gets out and a guy gets...

Suggestions on bpv lube?

Im having bad flutterdump from my speed6 at full boost let off. Mods include PG SRI, Forge BPV (blue spring 1 shim). Anyone have a good way to eliminate this?