Search results

Car is a 2007 CX-9 AWD A month or so ago, my air conditioner stopped blowing cold air everywhere in the car (front and back). Doesn't seem to be any issue with the controls or the blowers, just getting warm air blowing out of vents. After some research, I'm a little nervous about just trying to...

Ok, starting to see that now. Does removing the splash shield also allow enough space to get to the tensioner pulley? And should the breaker bar come in from the top or bottom? I was looking at it earlier, and there doesn't appear to be enough space to fit the breaker bar in there Any idea how...

Couldn't find a proper howto on here, so I'm trying to go off of the factory service manual. Here's the steps they list: 1. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.5].) 2. Remove the front wheel and tire (RH). (see GENERAL PROCEDURES (SUSPENSION). ) 3. Remove...

So far so good! Installed it slowly and as properly as I could, with the negative terminal disconnected (another mistake I think I made last time). Drove around for a little while with a meter connected to the motor input, and watched it changing as I changed the fan speed to assure it was still...

Thanks for the reply! Luckily, I was able to get the part replaced, it'll be here tomorrow. I was doubtful that such a short period could've damaged it, but I guess I was wrong. It ran for like 20 minutes like that. When I get the new one, I'll be sure to install it into the factory location...

So, I went ahead and jumpered over the resistor once I found the proper schematic. Sure enough, the motor kicked on full blast. Of course, there was no speed control, and it couldn't be turned off, but this made me quite confident that the resistor was the part that needed replaced Ended up...

So, I should probably start by apologizing for bringing up this topic, since it's been beaten to death so much on here, but I've been through everything I can find and could really use some advice on how to proceed It's a 2007 CX-9 AWD The problem started with both the rear and front blowers...