Search results

  1. H

    FS, PA 2003.5 mazdaspeed protege

    Hello. same as my other car need to sell. this one has a lot done on it. also have lots of extra parts an extra shell, doors, engine parts etc, bought a parts car for a motor, and have lots let. had a forged motor built for it. hard piping. front mount ic. tien springs. solid motor mounts. the...
  2. H

    Fs: Pa 2010 rx-8 r3

    Hello. have to sell my baby lost job 2 years ago and need funds. bought it new, one owner, custom paint job done parts off. all mods where to prolong the life. care for the car greatly, only issue atm is i think it needs a clutch master or slave cylinder, starts like a champ. full coils wires...
  3. H

    AFC-SS Tuning PA tri state area? i will travel

    Hey alls, got my 03.5 msp finally running GREAT, after 3 motors, 2 cranks and a s*** tons of swearing and money, its feels strong all the way to 15 psi, but...... i have a afc -ss installed, *was on car when i bought it* and i have a forged and built block aswell. i am looking for a dyno tuner...
  4. H

    ITS Finally ******* ALive Again WOOOOTt

    hello Everybody. not sure if anyone remember me, got my msp about a year ago. about 2 weeks later got oil starved and blew motor. found a used msp and drove 800 miles one way to tow it back home. $2500 spent 3 months in spare time swapping motor over, got it running and drove it to work and...
  5. H

    think i blew my 2nds motor time for motor number 3 =/

    long story short, got the last motor in, had a blown head gasket, replaced that, and less than two weeks later driving home last night, just getting into boost 3-5 psi, heard a snap and the sound of metal and glass having a white trash meth induced bar fight inside my motor, needless to say she...
  6. H

    engine swap done, now wont idle?

    ok got the swap and everything done, it runs and drives ok, but after it is warmed up it wont idle and just dies it will idle for 10-20 mins (its cold here) just fine, but once it warms up idle keeps falling smoothly but quickly, i can catch with throttle and hold it and extremely light...
  7. H

    motor replacement almost done need a few things

    hello all, if you familiar i got 2 msp's now, bought one for motor got swap almost completed, but a few hoses etc i dont want to get messed up. water outlet pipe, lt side of block (if you are sitting in car) front part goes to rad, rear goes? there are 2 metal tabs on the wiring harness, they...
  8. H

    engine swap need a little help

    well if anyone read bought my msp about 2 months ago, 3 weeks later blew motor, 3 weeks later drove to NC and bought another msp to swap motors. long story short, this is what i have got done motor in tranny intake exhaust turbo power steering ac alternator. well got most reinstalled but i am...
  9. H

    new owner 2003.5 msp yellow =) PA

    hello all throwing in a introduction post here. just bought my msp 2 weeks ago and have been loving it since, few minor issues but getting those sorted. live in PA with my wife and we both love cars and racing and we both auto cross alot. current vehicles my daily driver. 03.5 msp yellow...
  10. H

    bad idle, low oil pressure lamp at idel, then died code p0340

    hello all. ok picked up a 2003.5 msp, has good but of mods, but current issue: yesterday idle was bad, as soon as it is above 1000 rpm it was fine and oil pressure lamp went off, but under idle lamp was on and it would drop to almost 0 rpm and die once in awhile, today, started fine and...
Back