**********-Is it possible to still get in on this? If so, I want Setup A with black connectors and can give you my credit card info tommorow. Let me know ASAP.
KyRaceFan-OEM Potnezas with 14,XXX miles.
mazdaspeedchick-When were you at the track? I was there Friday from like 7:30 to 10:30 and Saturday from 2 to 4.
Reaction Times:
1st Run: .326
2nd Run:.212
Went to Island Dragway again today even with my broken downpipe. Only did 2 runs today and I'm very happy with the out come:
1st Run:
60'....2.348
330'...6.317
1/8....9566
1/8 MPH...75.50
1000'....12.366
1/4....14.744
1/4 MPH...94.39
2nd Run:
60'....2.227
330'...6.179...
All the runs were running 8 psi. I already ordered my FCD from JoeP and will be going back to the track when it gets here.
Performance mods are:
JoeP MBC
Injen CAI
APEX 3" Catless Downpipe
JIC Cat-Back Exhaust
NGK ZFR7F-11 Spark Plugs
On my 4th run i had an extreme amount of wheel...
Just got back from Island Dragway. It wasn't crowded at all. I got 12 runs in through the whole night. The average temp was 70 degrees with 100% humidity. Here are my best runs:
9th Run:
60'......2.357
330'....6.377
1/8.....9.658
1/8 MPH....75.09
1000'...12.470
1/4.....14.876
1/4...
All Boost-I have a APEX 3" catless downpipe with a JIC 60mm(2.4") cat-back exhaust and it sounds awesome. Sounds like a WRX up to about 3000 rpm and after that it gets pretty loud but sounds real deep and not like a Civic or Integra. I get compliments all the time on how it sounds and people...
I'm installing my Defi air/fuel ratio gauge and just need some help on what wire to tap into. I already have the illumination wire, ground wire, sender wire, and 12v constant wire hooked up. I just need to know where to tap into for the 12v ignition wire? I've been searching on the forum for...