I have a 2010 Mazda 5 that had issues in the past with the transmission computer throwing a bad solenoid code and going into limp mode. When looking to replace the solenoids I found a listing on ebay saying that if you get these codes the transmission computer is bad and has to be replaced or...
Got into an accident with my 2010 Mazda 5. Airbags did not deploy but since the collision the airbag light is flashing code 12. Hooked it up to FORScan and am reading codes B1318 (low voltage) and B1342 (ECU defective). From what I have read B1318/code 12 indicates the ECU has bad capacitors and...
I am in need of some advice. I had to have my O2 sensors replaced on my 08 MS3 for some unknown reason around 2 years ago at ~20k miles. I mentioned to them that I was getting poor gas mileage and that I thought that the engine was running rich - causing the O2 sensors to foul.
The dealership...
I did NOT have to cut the rear support bracket to fit my AVIC U310BT so make sure that yours won't fit before you cut anything. I didn't fit at first but once I moved the wiring harness out of the way it popped right in.
No mods, car is bone stock (except for the radio). I used to get around 13-15mpg around town, but now I get about 16-18mpg after changing the spark plugs. I think the old ones had gotten fouled.
Car has 34k miles. I changed the spark plugs, air filter, (and front brake pads :() at 30k. The O2...
So I have been getting pretty poor gas mileage compared to most people's MS3. Recently I took a 600mile trip which was mostly on the interstate with windows up and AC off. I only got about 24mpg.
I was talking to one of the salesmen at Mazda when I bought my wife's 2. He owns a heavily modded...
Just bumping this thread to find out if you needed to cut the rear support.
I am installing a Pioneer AVIC-U310 into my wife's new 2 and just bought the Scosche kit. Anyone have any experience with it?