Recent content by marshmallow

pcb, I wish that was the case. I can adjust the brake and pull the parking brake a few times and it will just back itself out completely. If I wanted to, I could adjust the pads daily. Based on your picture, could I back the adjustment screw out completely and put some loctite on the threads to...

sorry for more old thread revival. I'm currenty searching for answers on this and can confirm that the 1109 fits and threads, but does not hold pressure out of the box

I've replaced both of my rear calipers and I do not have a "favorite." However, on the barake pad adjuster on both calipers backs itself out, leaving me with no parking brake. I probably got rebuilt calipers from O'Reilly.

Pm sent

What's a good gear fluid to use? My dad is an old VW mechanic and says Redline mtl fixes all of their problems with matching the syncro matching in 1st gear & reverse, but is unsure of the effects on the Mazda.

Any tips on taking the cd player apart other than precision screwdrivers?

anybody have any tips on getting the whole thing back on? im having a really hard time getting the rear part of the control arm to line up to where i can actually line up the bolt. its a really crappy situation

sold

I'm selling my mp3 ecu that i had installed in my protege5. I like it a lot, but i don't benefit enough from it to justify keeping it. This will ONLY work with a 2.0 liter FS-DE engine with a manual transmission and requires you to run premium gas. Good for a 3-4 hp gain. I am asking $265 flat...

If you pull up the carpet on the passenger side there is a little hole under where the passenger's feet would sit. If you see any part of XCF2 then you have an mp3 ecu. Keeps you from having to dig the whole thing out.

Did you have to do any camber correction? How much is the drop?

When i installed mine i remember reading something about installing a ground loop isolator. It's a part they sell at radio shack that prevents a grounding problem whenever you use the auxmod and charge your mp3 player off the cigarette lighter. THis being the only difference in your setup and...

so... any thoughts on the final product?

I've been having this problem too. My passenger side low beam is also noticeably dimmer than the driver's side. After inspecting the connector i noticed that all of the terminals were burnt up. Now i've gotta find a connector somewhere, and i've got the same problem the westerboyz has with the...

how much does a universal oxygen sensor run in comparison to the oems at protegegarage.com($120)?