Recent content by Haasdaddy18

I seem to have a pond of water in my spare tire well does anyone else have this or had this? If so whats a good fix other then just draining it I dont want a rust issue.

Awesome I got it off thanks!!!

I need to take the panel off the rear hatch but dont want to break anything clips or plastic. Anyone know how the easiest way to remov it without breaking anything is?

Awesome thanks!!!

Question what year of sti is the lip made for I love the looks of that one but cant find which on fits?

What front lip does everyone use I like the one that goes up on the sides. I know they are for an sti but what year, looking for a cheap option to dress up my 5

I heard a slight sucking sound and started wiggling stuff came to the fuel rail and one injector was a little wet around it took it off and the seal that goes into the manifold was bad

Nevermind problem located I have a bad injector gasket

I swapped the motor out on my 5 and put a motor in that I heard run when it was pulled from the car now it will start but will die at low rpm if you hold In the gas just a bit it will stay running any suggestions?

Started It up today but have a question So I just did a motor swap old motor spun a bearing and I picked up a low mileage swap for it and was able to start it today. Question though, when I hooked up and batter and put the key in it looks like my odometer display is busted, I know when I parked...

Thanks I got the rotors off just took a lot of on blast, as far as the motor I pulled it because the previous owner spun a bearing and I picked up a 120000 mile motor for $400 off craigslist. It didn't have the cat and mine was in pieces in the motor I pulled. I don't really want to have it...

I have an 03 MP5 and the cat is all broken up I pulled it all out will the car run ok without replaceing or do I need to order a new one, second the rotor will not come off is there something I'm missing to get it off I have removed the axles because I pulled to motor?

I'm used to seized hardware I'm building a 41 chevy rat rod also thanks for the heads up

Thanks!!

I'm getting ready to pull the motor in my 03 I'm down to unhooking the transmission and pulling it. Is there any advice or tools out of the norm that I should need. Also does anyone know the socket size to pull the wheel hubs? Thanks