Lacquer Thinner... A LOT easier to find them 3M adhesive remover, fine on your paint, and cheaper. Works great for removing adhesive, that's what I used on my door moldings.
I got mine off eBay and compared it to my friend's OBX he ordered through protegegarage.com. They are identical and my ebay OBX header works/sounds/performes AWESOME!
I am having a problem when I first accelerate after starting my 2003 MP5. I just installed OBX headers. I also have a CAI and cat back exhaust. My check engine light is not on or anything. When I first step on the gas and accelerate it's as if the car doesn't mix air/fuel properly. It has...
Ok, I took a chance and went and replaced my o2 sensor, and it worked. My car works, and I am STOKED!
Just a hint: I didn't know that you're not supposed to touch the ends of the 02 sensors. I know I touched it during my header install, and I blame that for making my o2 sensor go out. DO NOT...
Ok, I just made sure that everything was on tight, and I don't see any leaks. I reset my ECU and after about 3 min the CEL came back on. I checked what the engine error was and got the following info:
P0031
HO2S Bank 1 Sen 1
Heater Circuit Low
I'm thinking I might have f'd up my o2 sensor...
I just installed my new OBX headers into my '03 MP5. I also installed the non-foulers as described in the forum. My CEL came on within 10 miles after th install. I realized that I didn't put a gasket between the two non-foulers, but I did put one between one non-fouler and the header. Before I...