Recent content by dandan2

Unless u want to leave it open till he gets the items

Yes sir. The whole shebang

Sale pending to twinrotor.

Sam Is jdmsam. He is well known for his knowledge of this platform and has built more of these motors then anyone

Remember he is wanting a rim a half inch wider then urs

Pretty exciting stuff

They will be fine. There are other weak points to attend to well before 400 hp. People are blowing built transmissions on the mid 300's. I say that's the sweet spot for these cars anyways, 300-350hp, good suspension setup, LSD, good tune on standalone= one he'll of a ride.

http://www.mazdas247.com/forum/showthread.php?123803182-F.S.-Forged-motor-greatness&p=5772321&highlight=#post5772321

Parting ways with the build. May be parting it out sOon and gettin outa the payment. I'm gonna build an e36 coupe with a 2jzgte

Nope, e36 and swapping in a 2jzgte

Well my build has come to an end. Internals are up for sale but my dreams will live on through u r build seeing as u went with the same setup. But for me my happiness will come from no car payment 2 doors, 2 turbos, 6 cylinders and rwd.

If u wanna match his build check out my forged goodies for sell. Great deal, I paid more then I am selling them for and they are brand new. I'm local to sam and could easily bring it to him to assemble. U won't find this setup for cheaper and I have one of the only coated piston sets left. It's...

Bump

Yes, they are .020 over stock. As stated, the blocks alreant weak the rods are. When the rod snaps at that kin of rpm it shoots through just about any block. I also had my motor blow on me 3 days after purchase, luckily I also purchased an aftermarket warranty that covered it with only 300 outa...

I have a block, crank, and everything needed for a rebuild for sale right now. The pistons are only a tad lower comp. then stock and the rods are slightly longer, this helps decrease stress put on the bottom end. Lemme know http://www.mazdas247.com/forum/showthread.php?123803182-F.S.-Forged-motor...