Recent content by CasopoliS

I guess the defrost vent to the left of the driver (on top of the dash) would be a good starter. A few people have shown interest in putting a gauge in this area.

can someone help me? I need to know if the Mazda 3 4dr dash is the same as the MS3 hatch. I have a Mazda 3 I could probably use for development. thanks!

I often think the same thing about NW Ohio :)

thanks! but yea.... cinci is far.... hmmmm

bump

Thanks for the pictures!!! bummer, I thought there was a storage space up there. Well, maybe I can match the contour and just have something sit on top of the dash. Or maybe I could make a pod for the left-side of the dash between the pillar and console.

I don't know but it would help my cause out!

I would like to design some custom interior pieces for Mazdas... particularly the Mazdaspeeds that would enjoy some extra gauges / accessories. Looking for individuals from NW Ohio or SE Michigan. First meeting is a design meeting. Some dash disassemble might be needed. Measurements will...

I will try to find someone local and develop something. Might not be quite the same, but maybe I can get close. Anyone have pics (or link to pics) of the interior where gauge pods might go?

Someone find a MS3 local to North-West Ohio, and I will try to develop a gauge pod customized for you guys. Custom fit and look, without the 'custom' price. Hopefully I can come up with something.... I just don't have a development car. After looking at some pictures, I am sure I could make...

I will say a prayer for the poor pooch. Good luck.

The material is a rigid thermoplastic. I would love to see a picture of the console as it sits in the car, then possibly obtain the console and design something for it. The design and prototyping phase would not take that long. Anyone have pictures of this?

fyi the rear sti brembos won't even fit my legacy GT.... and they are both Subarus with the same bolt pattern! more work than its worth and it might not even work. STI had a different bolt pattern in MY05 I think... 5x114 rather than 5x100

Well I had a boost tuning issue yesterday. It put down 271 whp and 286 wtq at 15.5 psi and nothing done to timing. Boost issue is fixed, so I am going back and we are going to tune to 19-20 psi and then tackle timing, which is the fun part. 300 whp for sure, and probably 330+ wtq.

www.prosportgauges.com if you get enough people interested, I can extend my discount to this forum. They are great gauges for the price. They have been field tested and perform just as good if not better than Defi and others. These tests were performed by an independent company. I will...