Recent content by Bobbyb3

When you get the code there is stuff in the hose. The new hose doesn't allow stuff to keep getting on the sensor. See report. Mazda Pressure

Did you replace both CG36-42-580A...........Evaporation hose assembly with FTP sensor MSRP $ 227.88 CG36-42-580A - Hose, evaporation. Engine, fuel, tank, transmission - Genuine Mazda Part L5E1-18-791A............. Short cord MSRP $ 52.39 L5E1-18-791A - Cord, short. Engine, fuel, tank...

CG36-42-580A...........Evaporation hose assembly with FTP sensor MSRP $ 227.88 CG36-42-580A - Hose, evaporation. Engine, fuel, tank, transmission - Genuine Mazda Part L5E1-18-791A............. Short cord MSRP $ 52.39 L5E1-18-791A - Cord, short. Engine, fuel, tank, transmission - Genuine Mazda...

Yes as stated here is the info on the Mazda TB on how to resolve this issue.

It was an easy task. I just jacked up the back of the van. then hose is on the back side of the tank, no need to drop it. You will use flat head or wire cutters to break the retaining clip. I think it was green. Then it slides off. Slide the new one on and connect the new cable. Since this was a...

Yes here is an updated link https://www.autoserviceprofessional.com/articles/6282-mazda-pressure I replaced the 2 parts CG36-42-580A...........Evaporation hose assembly with FTP sensor L5E1-18-791A............ Short cord and it fixed all the problems.

Possibly The hose and sensor came as one piece so I didn't look to see if the sensor could be removed by itself with out damaging it. The hose has one time snap lock on all the ends so once it's off it has to be replaced.

That is because the problem was the position of the sensor so I get to keep the cable tight they had to adjust it.

Yes that part and one more. Here is the link to the service bulletin about it. https://m.autoserviceprofessional.com/article/94019/mazda-mil-whats-the-angle

Looking again today I think I my have found the sensor part CG36-42-580A. But still has anyone else had this problem?

UPDATE. This has been resolved My CEL came on the other day and the code I am getting is P0451 - EVAP System Pressure Sensor/ Switch Circuit Range/ Performance. I have notice it is burning more gas. When I look up this code most peoples solution is to replace the Tank Pressure Sensor TPS but...