Recent content by Balla

Youre the man. One last Q, on the pinout in the Flyin Miata directions the pins are all blurry and 3O looks like 3D. I'm pretty sure that 3O is grey/black, but I can't really tell. If I start on this before you reply I'll just vampire tap both before I solder anything to figure it out. Thanks...

I guess i should have asked when I asked for the O2 pin, but could you check the manual for the RPM signal too? (help)

Thanks for the links, I appreciate the effort (2thumbs)

Any luck finding that pin?

Thanks a bunch, I really appreciate it (mswerd)

I meant of where the harness is located in the car. Also, I have an air/fuel gauge, does anyone have an ECU pinout diagram or something that shows which wire to tap on the ECU for the O2 signal?

Thanks for the tip. You wouldn't happen to have a pic of the harness off hand would you? I'm going to check out the FD forums now...

I have a few gauges and a turbo timer that I want to install in my mazdaspeed Miata, and I was just wondering if there was a write up or how-to on here somewhere. Basically all I want to know with the gauges is where to go through the firewall. Thanks in advance.