stock sub wiring??

[maxchao]

I posted this thread in the audio section but didn't get any response, i guess this is also very P5 limited so I would post here again.

I just bought the stock spare tire little sub, and my car is not prewired so I have to wire them all.
I have no experience with car audio at all.(only some concepts) I thought you need 5 wires for this stock amp/sub but there are 8 wires on the harness.
I'll list the colors:
1.yellow
2.red
3.green/black
4.green
5.grey/black
6.grey
7.black
8.white/blue

they are like this put in the harness:
1 3 5 7
2 4 6 8

And, on the sub there is a line above the connector saying "INPUT/ACC/GND/REMOTE/BACK UP"

So, can anyone tell me which line is what?
The only thing that I can guess out is black is ground...lol

Thanks!

Josh

 

[kidtaurus]

You could use a multimeter to figure it out. I will try and tell you tomorrow.

 

[i12drivemyMP5]

http://www.floptical.net/mazda/wire/

 

[maxchao]

I think the wiring diagram in the service manual doesn't include the stock subwoofer in there.
I can try to use a multimeter but I don't know how to use it on subwoofer to identify which wire goes to which.

Josh

 

[maxchao]

How stupid am I!? I forgot Action Jackson had posted a link for me to start:
http://www.team-integra.net/forum/d...forum=0&searchSort=dateDESC&ReturnPage=Search

Well, now it's time to study...

Josh

 

[maxchao]

OK let me copy from the sticky thread in the audio section

Pin 1: Green / Orange - Rear Right Speaker (-)
Pin 2: Green - Rear Right Speaker (+)
Pin 3: Brown - Rear Left Speaker (-)
Pin 4: Brown / White - Rear Left Speaker (+)
Pin 5: White - Front Right (-)
Pin 6: Red - Front Right (+)
Pin 7: Black / White - Front left (-)
Pin 8: Black / Brown - Front Left (+)
Pin 9: Black - Ground (see note below)
Pin 10: Pink / Black - Switched power, coonect to red wire in aftermarket harness.
Pin 11: White / Blue - Dimmer, not typicaly used for an aftermarket radio
Pin 12: Green / Black - Illumination, thanks twizyours
Pin 13: Blue / Red - Contasnt Power aka Battery aka Memory, connect to yellow wire in aftermarket harness.

So I will connect the red wire, acc to pin 10 on the stock HU, but connect yellow direct to the battery right?
Then where should the blue wire, System Remote Control Input, connected to?

Also,