Aeroforce Interceptor Scan Gauge

Status
Not open for further replies.

spdjnke

Member
:
08.5 CWP Speed3 GT (sold)
Hey all,

For those of you who don't know what this is, well just figure it's just like a Dash Hawk, (monitor/reset codes etc) but only better and in a very small and ingenious package and this one is the Mazdaspeed edition, logo and all is prompted upon power up with MS3 specific parameters. and damn is the shift light bright!! Only been used in the car for 3 weeks. gauge and OBDII connector only...no instructions (can't find it) you can print it from their website if need be...but so easy to use it's very simple to figure out without. The Gauge is 52mm and fits perfectly in a vent pod!!

http://www.youtube.com/watch?v=mD6TIBU30TM&NR=1

SOLD
 
Last edited:
Interesting. I may have a use for this, though I wouldn't be able to use this at the same time as my AP.
That price OBO?
 
yeah, I thought I had sent it but I didn't click on Reply. My bad. Anyway, i wanted it but have to settle for just the Hypertech for now. he he. Thanks man.
 
what parameters does this show? or what useful ones? afr, kr, fuel psi, boost, ltft, timing, bat... whatcha got?
 
Mazda (CAN) Vehicles CNI series gauges

1. INTAKE AIR- Intake Air Temperature
2. BOOST TEMP SENSOR Calculated actual boost air temp. based on sensor output
3. COOLANT TEMP- Engine Coolant Temperature
4. TRANS TEMP- Transmission Temperature (gas powered automatics)
5. RPM- engine Revolutions Per Minute
6. MAF SENSOR LB/M- Mass Air Flow (lbs/min)
7. DIRECT INJ PRESS Direct injection fuel pressure
8. INJECTOR PULSE WIDTH
9. INJECTOR DUTY CYCLE 0-100%
10. MANIFOLD PSI- Manifold Air Pressure (psi)
11. THROTTLE POS PCT- Throttle Position percentage (0-100%)
12. THROTTLE VOLTS- Throttle Position sensor output (0-5 volts)
13. MILES PER HOUR- Miles Per Hour
14. KNOCK RETARD- Knock Retard (degrees)
15. IGNITION ADVANCE- ignition timing advance
16. SHORT TRIM B1-short term fuel trim bank#1
17. SHORT TRIM B2-short term fuel trim bank#2
18. LONG TRIM B1-long term fuel trim bank#1
19. LONG TRIM B2-long term fuel trim bank#2
20. COMMANDED EQ RATIO Commanded Equivalency ratio
21. LAMDA Wideband O2 sensor equivalency ratio
22. A/F RATIO Wideband O2 sensor displayed as Air/Fuel ratio
23. O2 CURRENT Wideband O2 sensor current
24. BATTERY VOLTAGE- Alternator/battery output voltage
25. ENGINE LOAD-calculated Engine Load (0-100%)
26. Calculated Engine Torque (Auto trans)
27. Miles Per Gallon instantaneous fuel economy
28. Calculated net horsepower
29. VALVE TIMING Valve timing in degrees
30. Analog 1 analog input #1
31. Analog 2 analog input #2
 
Does it support data logging to watch later? The most useful feature for me is actually data logging.
And also could the units be changed to SI ones (not psi but bar, not pounds but kg, etc...)?
 
Status
Not open for further replies.
Back