Search results

It was the master cylinder. We followed the fluid down from the reservoir, and it was coming out the hose from the reservoir to the master, but wasn't getting passed the master. We took the master off and forced an airlock out. Hooked it back up and it worked fine after. Taking out and putting...

So last week my clutch hydraulic hose blew a leak. Obviously the clutch lost pressure, pedal went to the floor, and it stayed engaged. My uncle drove out to me, drove my car to his house with no clutch (the tranny took a beating), took the hose off, patched it, we bled the clutch, and it worked...

Would it be correct to assume worn front bearings would be causing the tire wear?

Thanks guys. I'm going to be checking the ball joints and tie rods tomorrow, and probably swapping the new rear bearing onto the other side to see if I can pinpoint the problem. I suspect it's the front bearings at this point. Probably need to be replaced and have an alignment after that.

I bought an 02 protege5 a couple months ago. It's a 5 speed and has 246 xxx km on it. It had new tires when I bought it. I've driven it approximately 1900km since I bought it and I'm experiencing excessive tire wear on the front tires. The tire wear is on the inner edge of both front tires...