• Got Stuff to Sell or Buy? You can post an ad for free in our Marketplace, just follow the Rules. Thanks!

Search results

  1. R

    Need help with engine mounting studs

    Hi,i was hoping someone could help me out. I need a couple M10 x 1.0 studs that go from the transmission to engine mount 4.On the drivers side of the car under the intake area. I tried the local dealership and they say that stud is unavailable or not serviceable. Was really hoping somebody has...
  2. R

    WTB front strut tower bar

    Need an oem or aftermarket front strut tower bar for gen 3 Protege
  3. R

    Need some cam caps

    My machine shop lost my cam caps,anyone have a set they can sell me please? for 2003 FSDE engine.
  4. R

    need cam caps

    Hi,I'm looking for cam caps for a 2003 mazdaspeed protege. Pretty sure they are the same as on all the 2.0 FSDE engines. I brought my head in to a machine shop to get it pressure tested and a valve job/resurface. Guy calls me back months later and says he did everything but the valve adjustment...
  5. R

    looking for a machine shop near Charlotte NC

    I'm having a bit of work done to my FS-DE MSP engine,my block and crankshaft needs to be milled and the oil squirters filled in.Plus the valve job work and complete balance at a local machine shop. This local guy does great work but has had my parts for about 4 months now and isn't finished...
  6. R

    looking for a machine shop near Charlotte NC

    I'm having a bit of work done to my FS-DE MSP engine,my block and crankshaft needs to be milled and the oil squirters filled in.Plus the valve job work and complete balance at a local machine shop. This local guy does great work but has had my parts for about 4 months now and isn't finished...
  7. R

    WTB MSP steering wheel/driver seat in great/good condition

    Mine has usual high wear,missing seams and worn open here and there. Hopefully looking for replacements or new old stock replacement/re-fabrications ideas even. Yellow stitch a plus.
  8. R

    Resurface Crankshaft or Replace it?

    Hi Guys,I'm rebuilding my engine with forged parts right now. Took it to the machine shop to have head work,cylinders bored,and balanced. The machinist shows me some troubling surface scratches on the crankshaft and lets me know he would have to take .10 off to use it,then tells me i'll also...
  9. R

    Which OEM ENGINE OVERHAUL GASKET SET can i use?

    Hi,I'm gathering up the parts to do a complete engine rebuild using forged internals. While looking for the OEM ENGINE OVERHAUL GASKET SET. What i noticed is that when i give my vin# to the dealership it comes up w/ part# 8MB410271 which is specifically for the 2003 MSP. But in the post...
  10. R

    WTB: Forged Internals kit

    Just ran a compression test and discovered my cyl 1 is 50 lbs less than cyl 2-4. Figured ill rebuild the engine since ill be taking it apart to repair the head or rings since it's close to 90k miles. Looking for wilco pistons with rings preferred. Crower,Pauter,K1 rods. I'll need head bolts/main...
Top