Wiring for Daytime Lights and Turn Signal

[Rutedown]

I got the instructions below to add some DRL’s and turn signals. Can someone show me where to tap into the turn signal? Wire color and location.

 

[Rutedown]

Found it! Now which wire should I tap into...red or blue?

Got my multimeter back. Looks like red is where I’ll be tapping into tomorrow.

 

[Mylo]

Can I ask where did you tap the ACC to? I’m having trouble finding a positive that's only on when the engine is on. TIA

 

[Rutedown]

Can I ask where did you tap the ACC to? I’m having trouble finding a positive that's only on when the engine is on. TIA

I can’t remember what fuse and what prong it was exactly in the engine bay, but here are my photos.

 

[Mylo]

I can’t remember what fuse and what prong it was exactly in the engine bay, but here are my photos.

Thank you so much, will check mine asap

 

[Mylo]

Thanks for the information, it let me finish mine today including a relay to turn off DRL when lights on.

Thanks again.

 

[dynamho]

Can I ask where did you tap the ACC to? I’m having trouble finding a positive that's only on when the engine is on. TIA

I used Tap-a-Fuse on this Meter1 fuse #41 to act as ignition ON DRL.
For the Tap-a-Fuse, I used 10A to simulate the fuse and 7.5A for the LED connection.

I'm recycling Rutedown's photo for Fuse #41 (Thanks, Rutedown).

You can also use Fuse #36 (15A) FOG if you want it to act like fog lamps.

 

[dynamho]

Thanks for the information, it let me finish mine today including a relay to turn off DRL when lights on.

Thanks again.

I still need to tap into passenger side turn signal.

How were you able to get past all the monster harnesses in the way? I can't get an angle. Did you remove the washer funnel bracket?