The service manual says to place the jack stands on the side sills. Does anyone happen to have, or can someone take, a photo of which areas the service manual diagrams are trying to show?
Gidday, If I remember I'll take some photos tomorrow of my car on stands
The rear jack point is directly in front of the trailing arm mounts,
The front point is a little harder to figure out in that drawing. I've used the body seam that runs the length of the car about 10cm in from the side skirt.
subframe option?...................might be option for krusty cars. Scissor jack should work there too......Depending on what surface car is on tho..............
I've always used the pinch welds. Where the little "divots" are in the front and rear ends of the pinch weld. Never had a problem. Most manufacturers specify those as the jacking points, hence the divots.