Got my short shifter in last night, instaleed it today. It is a B&M brand shifter.
INSTALLATION:
This was very easy. Took me about 30 mins. The instructions are very good. You will need to get your car up on ramps or use a floor jack or a lift. I used ramps and it was a tight squeeze, but I did it. You will need a 12mm socket and a 12mm wrench, or 2 12mm sockets will do. Ratchet, a 10mm socket, a phillips screw driver and a small flat head. Only pain is the shifter going into the housing. It will go most of the way, but will not go all the way. It needs to go down about a half an inch more than I got it, but it bolted up and shifted fine. I will have to take a hammer and tap it down.
PERFORMANCE:
It is shorter. NOTE: The stock shift knob WON'T fit back on it. The shaft is too big for the knob. I had to use my stock Integra knob on it for now. The shifter is noticeably higher than the stock one. Don't know if its cause I don't have it all the way down or it may be the Integra knob, or it may just be longer hehe. It is pretty good though and you will notice a difference in the throw. This combined with a clutch and flywheel should be a great combo.
MY VERDICT:
Get it. It is not that expensive and gives you a nice tight short shift. It is not the shortest I have seen, but it is better than stock.
INSTALLATION:
This was very easy. Took me about 30 mins. The instructions are very good. You will need to get your car up on ramps or use a floor jack or a lift. I used ramps and it was a tight squeeze, but I did it. You will need a 12mm socket and a 12mm wrench, or 2 12mm sockets will do. Ratchet, a 10mm socket, a phillips screw driver and a small flat head. Only pain is the shifter going into the housing. It will go most of the way, but will not go all the way. It needs to go down about a half an inch more than I got it, but it bolted up and shifted fine. I will have to take a hammer and tap it down.
PERFORMANCE:
It is shorter. NOTE: The stock shift knob WON'T fit back on it. The shaft is too big for the knob. I had to use my stock Integra knob on it for now. The shifter is noticeably higher than the stock one. Don't know if its cause I don't have it all the way down or it may be the Integra knob, or it may just be longer hehe. It is pretty good though and you will notice a difference in the throw. This combined with a clutch and flywheel should be a great combo.
MY VERDICT:
Get it. It is not that expensive and gives you a nice tight short shift. It is not the shortest I have seen, but it is better than stock.