New Product Release! JBR Reverse Lock-Out Gate Guide Gen1 MAZDASPEED3

JBR

Authorized Vendor
:
09' & 2011 MazdaSpeed3
The JBR Reverse Lock-Out Gate Guide is essential if you own a GEN 1 Mazdaspeed 3. After only a few thousand miles the OEM plastic gate guide will show wear from dragging the reverse lock-out peg. This wear is caused by the sharp reverse lock out peg being dragged against the guide during normal shifting from 1st to 2nd gear. Once the wear begins slop in the shifter becomes even worse than when the shifter was new! 1st and 2nd gears are the two most often used gears and wear happens fast.

MS3-RLOCK_01.jpg


Significant wear of the OEM guide can lead to there being no reverse lock-out. This can lead to a dangerous situation for the driver as well as accidental costly damage to the transmission.

MS3-RLOCK_02.jpg



The JBR Reverse Lock-Out Gate Guide is constructed out of .125" indestructible stainless steel plate to protect the OEM plastic guide. The sharp OEM peg has no chance of digging in and wearing through it!

MS3-RLOCK.jpg


The added .125" also reduces the side to side slop in the shifter and makes shifting in to 1st and 2nd buttery smooth again.
The cost of replacing the whole shifter cage runs hundreds of dollars. Now, there's a inexpensive solution that comes with added performance.

MS3-RLOCK_03.jpg


Includes:
Reverse Lock-Out Gate Guide
Mounting Hardware
NO CEL Guarantee
Installation instructions are available in our support section
Shipping is free in the US & our Hassle Free Lifetime Warranty is included
 
Back