Joe MBC Complete Install with pictures

[xsivspd]

These next pictures take you through the complete install of the JOE Manual boost controller installation.
Enjoy.
Get a pirce of 3/16 inner tube vacuum hose from autoparts store

[dominoy2k1]

[xsivspd]

Then take the vacuum tube off the Tee leading from the BOV to the Wastegate.

[xsivspd]

The next picture is what the Tube looks like off the tee.
My thumb points to the vacuum tube that came off the T and my pointer finger denotes the T it came off of.

[xsivspd]

Now connect your 3/16 vacuum hose you bought from the store and connect it to the T and zip tie it down

[xsivspd]

Now connect the the MBC to the Vacuum hose leading to the WasteGate amd the zip tie it closed.

[xsivspd]

Now the next step is to connect the BOUGHT 3/16 vacuum hose to the MBC then zip tie it.
(This picture just shows excessivive tubing which will be cut to proper length in following pictures.)

[xsivspd]

Now the next picture shows the MBC together to the two vacuum lines.
(Yes I know the vacuum lines are not zip tied down as of yet.)

[xsivspd]

The next three pictures show the final install.

[xsivspd]

2/3 final. All zip tied down.

[xsivspd]

3/3 final install.

[ARunto]

GOOD WORK!!! pat on the back to xsivspd...thanks for the pics

[xsivspd]

Boost Taken from before installation of JOE MBC.

[xsivspd]

After install of Joe MBC.
Weeeeeeeeeeeeeeeee.

[xsivspd]

This is my current look under the hood.
I made the cold air myself with parts that can be purchased from Performance Improvements in Toronto.