So this is the problem. I blew a hole in the block so I bought a donor motor and swapped all the parts over. Dropped the motor in hooked up the wire harness and to my dismay, the car would not start. At first the car would not even crank, so I checked all the connections from the starter, sensors, ect., and all seemed well. My brother came by and checked it out. He did exactly what I did except he stuck his hand under the intake manifold and fondled the some wires and vwalah! It started to crank! We still wondered why it was not getting fuel or spark, so I ended up buying a scanner and it read a P0335 code. We decided to replace the ckp sensor, to our dismay the car did not start and again the P0335 code popped up. Do you think it could be a loose connection on the wire harness? Has this ever happen to you? and Should I change the CMP? it was supposed to be a routine engine swap, but now its turning into a pain. I feel my knowledge of this car is pretty good, but this has me stumped. Please help, I would appreciate your suggestions as to how to get my baby up and running again. Thanks peeps.