Search results

i am wondering if anyone knows wether or not our msp ecu can be reflashed to remove the vtcs and all that junk. i am trying to keep my check engine light off without running the butterflies or valves. i still have the soleniods hooked up but it keeps throwing a check engine light right away. any...

so basically what i want to do is run around 15-18psi daily. what im curious about is if the ss ftc will allow me to do that safely? also on top of that what would be a reasonable size for injectors? and before the question pops up, i have a build block and and built tranny. thanks for any input.

I am wondering if anyone knows the thread pitch for the EGR threads on the exhaust manifold? Thanks!

I'm looking for a stock msp intake manifold, EGR, valve and EGR tube. Pm me for a faster response. Thanks!

I'm looking for a mass air flow sensor for my 03 msp, pm me if you have one asap thanks

I need the stock oil return line off of the turbo, or at least the metal portion that bolts to the turbo. thank you!

i am looking for a mazdaspeed protege cv axle, preferably a damaged one, i just want the tone ring off of it for the wheel sensor to read. also i am looking for a stock sub enclosure out of the msp. pm me if you have what i need thank you!

i am just finishing up putting my motor back in and im stumped on what plugs into the connector under the intake manifold. i know the one that plugs into the alternator and the oil pressure switch but the one im talking about is a two wire connector, the connector itself is grey and its right...

I'm looking for the stock sub enclosure for my msp, with a working sub and amp. pm me if you have what I need

For those of you who have replaced the rear main seal, how did you press it in? It says to use a special service tool, but i'm wondering if I can get it in the correct depth with something different.

I am wondering how many users here are running the doc b set up with the prv and remote filter also using the OE oil cooler. Im having an issue with my bypass adapter, there is a gap between the adapter and oe oil cooler with the adapter bottomed out on the threads. Any help would be great as...

I'm looking for a ring gear to use with my Mfactory LSD, its for my MSP pm me if you have what I need thanks

Does anyone know the torque specification for the bolts that hold the mbsp to the block?

I am curious if anyone has done this, it seems simple but i'm just looking for advice on how to do it, thank you!

I am wondering if anyone has taken apart the center dash bezel, where the radio sits and the hvac controls. i am trying to get it apart right now to put in my 3 gauge holder in the din. the problem im running into is the hvac controls are stuck to the bottom of the trim piece that surrounds...

Alright for all of you who have welded lsd's I would really appreciate pictures of where to get it welded/reinforced. Also are there any seals and such I should replace while my trans is apart?

im looking for a gt28rs, gt2871r, or a gt3071r. im also looking for two spal slim fans 12" lmk what you have thanks!

I was wondering if anyone relocated their battery to the trunk? How did you go about doing it? I really want to clear up some space in the engine bay.

I'm looking for a Garrett t25 gt28rs or a gt3071r turbo, pm me if you have what I need, thanks!

Im wondering if i can have a plate made to block off the oil return in the main bearing support plate so i can run the turbo return line the my new awr oil pan. thanks in advance.