Recent content by SLSPERFORMANCE

http://www.slsperformance.com/slsp/InfoPage.asp?idPage=14

NO Revised SLS mount bracket's have ever broke. Sounds like you a very old bracket. contact us for getting it replaced! Old one does need to be returned to us. http://www.slsperformance.com/slsp/InfoPage.asp?idPage=14

Usually the testing place dosent even look under the car they now just plug in the testing machine and it tells them if all teh sensors are working. since there is no o2 sensor behind the 2nd cat the test comes back fine.

The imprint you see is from our press where we pressed the bushing in.

If we can get 2 people that will purchase the manifold, we will build 2 of them. We would need 2 for sure people to make it happen.

The company doing that is not far from us. The owner is named Rob(Not MAM) to help clear up the confusion. I have seen MAM's welds and they are far cleaner than those pictured. We own the MAM MSP tubular manifold jigs. IMO, it's one of the cleanest and well designed manifolds I have seen, but...

You can send in the bracket and get a replacement. As for the front motor mount breakage and worries, you have no worries at all. We have posted several times in different threads explaining that the resent breakage is limited due to the number welded by our new welded. There is no concern with...

The old brackets where made from 3/16" thick aluminum. We have sold over 50 sides alone and have had 5 failures. This is a concern so we now are switching over to steel.

We have redesigned the side bracket and will be sending our replacements. The new bracket is made from steel and we feel this will eliminate the failures.

The breaking issue is now under control. The side motor mounts will now be coming with a steel bracket and this will eliminate the bracket failures.

Your mount is not going to have any issues. The truth of the matter is only 5 set's where welded up by the new guy and only a few made it out the door. Those that did make it into customers hands have been contacted and asked to return them. So, if you did not get an email or phone call you have...

Welding the nuts has been a concideration for a while. As you all know yes we did buy the jigs and designs from Beau/MAM not realizing we would have problems. All the mounts we tested before sending them to the public have all been fine (No breaks, cracks, or vibrations) so we are a little...

The problems have been fixed. We have sold over 150 side and front motor mounts and have never had a mount break until we brought on a new welder. The issue was due to lack of welding penetration and has now been rectified. Our mounts are guaranteed against defects and we will replace those with...

We have just finished inspection on the last batch and they are now again ready to ship out. Again anyone having problems with there mounts call or email us (PLEASE NO PM'S FOR WARRANTY CONCERNS) Contact us so we can get you an Return Authorization # so we can get them exchanged. For new...

Warranty on mounts Well as you see it finally happened. A defective front mount! From the pictures you sent it looks like the weld didnt penetrate far enough thats what you get unfortunately when you can't build everyone personally. We hired a new welder on the last batch of mounts we made...