Recent content by jhines142

Sorry to resurrect an old post, but, the pictures aren't working for me. from the 02 sensor to the bung does it go, o2 sensor w/ original washer, big hole, gasket, little hole gasket bung?

pm'd

Hello all. I am in need of a replacement engine for my P5. I am looking to buy a long block, w/o accessories. Currently reside in Cincinnati, Ohio, however will meet if necessary as long as it isn't too far and the price is right. Let me know what you have!

Ok, here's the skinny.. I have an electrical ticking when i hit the throttle, using my hand, pushing down rather quickly. I was simulating my foot hitting the pedal down in a rapid fashion, but not WOT. WTF is causing it? Now, I can tell you for certain that its intermittent. Another thing is...

Hey all. My name is Jason and have owned a P5 for a little over two years now....just haven't really had the time to get on here. Looking for other Mazda owners in cincy as well as possible help on a few things.

OK so while trying to install a new intake tube I broke my MAF. Is there anyone in the Cincinnati Ohio area with an extra :p I really need one . Thanks.

Lol my camera phone sucks

Hey guys, could someone take a look at my pics below and tell me if anything, besides the obvious, is wrong or looks odd to you? [/URL][/IMG] [/URL][/IMG] [/URL][/IMG]

Hello everyone. My name is Jason and I am the proud owner of a 2002 Mazda Protege5 5spd. Living in Cincinnati, Ohio, anyone else in the PR5 community here should message me. Always looking for more friends.

Update: brakes, so far, are working as they should. Now to save up for pads and rotors all the way around.

They both adjust fine........did u notice that they dragged a little before they adjusted themselves

I know this has come up VERY often as our rear brake calipers are suuuuper finicky. Ill try to be as un-noob-ish as possible. I know to properly adjust the rear calipers is to turn the allen key until the pads grip the rotor, then back off up to a full turn max to keep the brakes from dragging...

Well I took off the wheel and tried to retract the piston with the Allen key. No luck. The caliper piston will move out ( as if I were pushing the brake pedal) withe the Allen key but will not retract. Will be getting a new caliper Thursday more than likely

Just drove home from work about 11 ish miles again. This time all four rotors are warm but not hot. However passenger rear kinda smells like burning plastic

Also forgot to mention the passenger rear caliper was really gunky when I replaced the pads