Recent content by CaptainCrunch

Tools needed: 7mm hex wrench with 3/8" ratchet drive, pliers, special homemade tool (see below), coat hanger wire, emery cloth Step 1 With the vehicle in park on a level area, set the parking brake, and block the front driver side wheel to prevent the car from rolling when lifted on the...

Tools Needed: 7mm hex wrench with 3/8" ratchet driver, pliers, 6 C clamp, coat hanger wire, emery cloth Step 1 With the vehicle in park on a level area, set the parking brake, and block the rear passenger side wheel to prevent the car from rolling when lifted on the jack. Slightly loosen...

How the Bulb looks with and without the H7 Socket Adapter I realized after the job was done that I should have taken a picture of the new bulb next to the old bulb connected to the H7 socket adapter. It would have made it easier for others to see what to expect. But I wasn't about to undo the...

Mazda 5 Headlight Bulb Replacement (Low Beam) A. This is a frustrating job for most people because the opening in the back of the headlamp is too small for even small fingers, and it takes considerable force to release and re-tension the metal clip that holds the bulb in place. I've found a...