A Pillar swap for gauge pod

[poboxjosh]

Does anybody know the color of the A pillar on the 03.5 MSP. Mine is Titanium Im not sure if all the A pillar colors are the same. I just bought a 3 gauge pod and i want to paint it to match the current interior color. Has anybody done this if so what color paint did you use and maybe where did you get it if you know that much. Any help would be great.

[KySpeed]

check out hte mazdaspeed protege draggers parts guide it hink its sticky, theres a link for paint in there. its near stock color

[CChris704]

i'd recommend just getting as close as possible and painting the a-pillars. I went through about 5 cans of spray paint before i found a decently close match. search and you'll probably find some stuff on it.

[ONRAILS]

as did I. Finally I went to home depot with the piller in my hand and had them match it. Brushed it on.




i'd recommend just getting as close as possible and painting the a-pillars. I went through about 5 cans of spray paint before i found a decently close match. search and you'll probably find some stuff on it.

[F8T@L SP33D]

as did I. Finally I went to home depot with the piller in my hand and had them match it. Brushed it on.

Go to home depot and have them mix a quart of Behr Premium Plus Int Satin Enamel, Pastel Base (7500) with the following colarants: B Lamp Black, OZ-0,48-10, 96-0; E Thalo Blue OZ-0,48-2, 96-0; L Raw Umber OZ-1,48-28, 96-0. Make sure and tell them you want a flat paint.<!--QuoteEnd-->

[Protege2K]

If you don't want to go that route. A flat gray primer matches very well. That is what I used on my triple pillar pod and it looked great. Total cost was like $4.