Wanna wire up my V1- how to route under headliner?

[rocketspeed]

Anyone know? Easy enough to take off the pillar and run a wire up from under the dash, but how do I get from the top of the pillar to the middle of the headliner near the rear view? Anyone do this?

[Reitrof]

I have P5 so I am not sure if it is the same as the Mazdaspeed but in the P5 it just tucks up in the front where the headliner meets the windshield. Ran it to the A pillar and down into the kick panel.

[toucci]

when I did this on my other car I had to remove almost all of the headliner with its nasty goo and I ran it along the edge until above the headrests and made a 90 degree angle

[rocketspeed]

I have P5 so I am not sure if it is the same as the Mazdaspeed but in the P5 it just tucks up in the front where the headliner meets the windshield. Ran it to the A pillar and down into the kick panel.
I think its the same. I was thinking I'd tuck it up there, but was wondering if anyone had routed it under.

[alexlitov]

just tuck it in.

[t3ase]

yup.

[t3ase]

You can also remove the driver's visor with five or six screws if you want to make it easier, depending on your hands.