I am having problems.

[YayArea420]

I am having problem with my cars RPM's dropping to 0 and then jumping back up again. It only happens when I push in the clutch. Everytime I push in the clutch it happens. The only mods I have are turbo hoses hardpipes and a drop in K&N. Also when I am full throttle the car gets to about 5500 rpm's and doesn't pull anymore, it that normal? Any help is appreciated. Thanks.

[RyanJayG]

I wanna say boost leak

[TX Speed Demon]

Did it start when you put in the pipes? Sounds like a boost leak to me too.

[irr5302]

leak after maf adjust the intake plastic pipes

[DSMConvert]

clutch sounds like a bad/ceased pilot bearing/throw out bearing....so when you push the clutch in it acts like it wants to stall correct?

[YayArea420]

Did it start when you put in the pipes? Sounds like a boost leak to me too.

No it started later, but I did take them off and put them back on and it started shortly after that.

[YayArea420]

clutch sounds like a bad/ceased pilot bearing/throw out bearing....so when you push the clutch in it acts like it wants to stall correct?

Yes that is correct. But some times if I leave it in gear and I am slowing down if I wait and push in the clutch at around 1500 rpm the idle will just drop to normal.

[StreakinOraNgeX]

Leak somewhere in your pipes. Yea boi, yay area 925 rep dat shiett.

[YayArea420]

Leak somewhere in your pipes. Yea boi, yay area 925 rep dat shiett.

Cool I am about to check on it after work. Reppin 510 here!!

[YayArea420]

I just went and checked all the places I could to see if there was a loose part but no luck. Should I take the pipes off again and just put them back on making sure that they are tight. I hope it isn't anything serious cause I don't want to deal with the dealership again.