Problem with IC Nipple

[Skee2211]

can anyone think of another way? I tried that whole JB weld thing let it sit over night and as soon as i put it back and let it boost once at stock no boost conntroller it ripped right off? What do you guys think would happen if i just disconnect it from the nipple and just plug that hole up? Do you think that would be a BIG PROBLEM????

[mspdfreak]

the nipple on the plastic turbo to IC pipe?

[t3ase]

Use 3500psi strength epoxy found at automotive stores. Let it sit for a few hours at least. That's how my current pipe is.

Do *not* block that hole.

[RyanJayG]

haha.. he said nipple....


and on a more serious note, hairspray makes shit stick

[t3ase]

haha.. he said nipple....


and on a more serious note, hairspray makes shit stick
i heart you.

[RyanJayG]

thanks buddy..... <3

[Skee2211]

What if i just disconnect it and plug the hole?

[mspdfreak]

What if i just disconnect it and plug the hole?Then you just became a man....LOL.

[t3ase]

What if i just disconnect it and plug the hole?
I really hope you're kidding. Please learn about how a turbo setup works and then tell me if you want to "disconnect and plug" that hole.

[mspdfreak]

I said fuck it and bought hardpipes...

(by the way, I did the same thing when installing my Injen)

[BoOsTiN]

Yeah dude, don't plug the nipple.
Spend 5 bucks and fix it.
I actually used 2 types of epoxy to fix mine.
1st was Permatex Permaoxy plastic weld.
Used that to set the nipple back on (sets fairly quick). Then I used some Cargo quick steel epoxy over for some extra reinforcement.
Been holding for months now and even at 10#s

[JDM Sam]

lol plug it & tell us how compressor surge sounds.

[celdridge]

lol plug it & tell us how compressor surge sounds.


I bet it will go from Turkey to Supa Dupa Fly Turkey

[b00sted]

i heart you.
ghey