Tochigi Fuji Sangyo 2-way LSD Question???

[SirMichael]

What is the part number for the speed gear in the Tochigi Fuji Sangyo 2-way LSD. I am currently installing it into my 95 Probe GT and I got the wrong speed gear. So i'm guessing I need to get another one if anyone could help it would be great.

Pictures of Diff Here (http://forums.probetalk.com/showthread.php?t=1701102171)

I bought this off another guy and I am assuming it is form the MazdaSpeed Protege.

[SirMichael]

The speed gear that I have now on there had two notches hold the bearing from completly being pressed down. Maybe I can just shave those two notches off I dunno know but I need help asap.

[SirMichael]

What is the part number for the speed gear for the pinion shaft of a Mazda Speed Protege????

[JDM Sam]

Man...That was a waste of money, you got the revised LSD that sucks a fat cock. Read this thread for more info.

http://www.msprotege.com/forum/showthread.php?t=65857

Notice you dont have springs in the LSD? Here are pics of the original one that snapped in half.

http://www.msprotege.com/forum/showpost.php?p=950723&postcount=18

FYI
The SRT-4 is not supplied by Tochigi but Quaife.
The WRX I'm not sure.

No speed gear in MSP. MSP speedo is read by ABS sensors.
Get a MP3 or regular Protege speed gear. Lotta misinformation in that thread on Probetalk.

[low_psi]

pwnd.

[JDM Sam]

Info on the speedo gear prob you are having.
http://www.msprotege.com/vbb225/showthread.php?t=60567&highlight=quaife+install

[SirMichael]

What is the hosing made out of? Is the housing cast and the gear is steel. Im just tring to figure out. Cause Im going to try and get them welded. I wouldnt get lucky and them both be steel though, cause then I could do it. :(

[JDM Sam]

you have the revised LSD i dont think you need to weld it. the old lsd is the one that was weaker.

[SirMichael]

ahhh ok thats good to know... I just got finished fabricating a tranny brace so hopefully that will help also.