MSP/ Protege Sedan Question

[Kona Bear]

Quick question.

Do the back seats in the MSP/Pro Sedan fold down to allow access to the trunk? If so, is it the same as the P5 with the pull tabs at the far end of each seat closest to the door?

Thanks,

KB(strike)

[SpicyMSP]

yes.

[jersey_emt]

^^^^^^ beat me



Yes.

[protegeV]

so if this is the case, then will MSP rear seats swap with P5 rear seats?

I havent gotten a definitive answer to this yet, I have only been told that the rear skins are not interchangeable.

[low_psi]

Ray post up some pics of the mounting locations and I can give you a definate answer.

[protegeV]

will do...I'll take some tomorrow and post em up. I'd do it now, but night time pics with flash suck for seeing details.(shrug)

[low_psi]

ok. I'll let you knwo this week when I look at the ole' DX. The P5's have mounting points on the bottoms(bolts) where the sedans just pop in.

[protegeV]

so its the mounting points that you're concerned about? the top of the seat where it clicks into the rear(same part that allows the seat to fold down) is the same? That is what I was thinking might be different.

[low_psi]

yea, the bench is the part in question. the bottom clips into the car on the sedans were the p5's have hinges and bolts for the bench.

the p5's also have rear headrests, where the sedans don't.

[protegeV]

wonder if its possible to swap the hinges/bolts for the clips???

I know about the headrest thing...

[protegeV]

Ok, here are the pics. This has gotta be the best rear seat setup Ive ever seen. You pull straight up on the front ends then rotate them forward...and its a simple flippy clip thing that hold the rollbars in place. Very ingenious...Now I have to wonder if MSP seats will go in(nervous)

[protegeV]

sooooooo...