ION Performance Intercooler

[Packerfan]

Hey has anyone purchased and is using one of the ION Performances FMIC setup and if so how is it anyone have any numbers or dyno sheets before and after. Thanks

[Hypnotized]

Take a look at Turbo magazine. They did a dyno on this fmic before and after. I would post the results but I dont have the issue in front of me, I think it was like 10whp.

[03MSP]

around 13 whp gain consistantly...no heatsoak(from Turbo Mag)

[505zoom]

Originally posted by 03MSP
around 13 whp gain consistantly...no heatsoak(from Turbo Mag)

I'll second the no heatsoak statement. You can feel the IC---->TB pipe after a hard run and it is still cool.

[^tyrant^]

O/T 505 do you have any pic of your engine setup, mostly the intake part ide like to see how you have the injen hooked up with the FMIC

anyway im planing on getting the ion fmic after i get my exghaust done.

[505zoom]

I have changed it quite a bit. Basically, there is a flange for the stock BPV on the lower part of the IC----->TB pipe. It's pretty much right underneath the maf and injen. You stick a hose on the flange that runs to the BPV, and then another from the BPV to the injen. This is an old pic, but it's the only one I took of the stock valve on the new setup:
http://www.mazdamp3.com/members/505zoom/dsc00531smaller.jpg

I have cut the injen hard line down to a nipple almost, and I ran some blue silicone hose from the BPV, underneath the IC piping, and to the injen. It looks way better now.