FCD install

[ZMN BY U]

Help i cant find any pics or install instructions on the joep FCD install does the FCD go under the hood or under the dash and which wire to tap into the green with the black stripe..Help!!!!!

[girth]

Didn't Joe send any directions along with it?????

[soundbombing]

mine came with directions. I would keep it under the dash. you just have to wire through the vacuum line or use the boost gauge line to tape off of. mine is under the hood since the maf wire (middle one) was easy to get to, i had a good ground, and i could T off a vacuum source. i'm moving it this weekend.

the fcd is so BALLER, i can acutally floor it @ night and it pulls like a mother. it was rough and sluggish but everything is smooth. right now for me 2nd gear is basically useless with brand new es100's i just got. not that loosing traction is a good thing, you are actually slower but shows my hp increase and delivery. later.

[ZMN BY U]

tHANKS SOUND BIG HELP DUDE CAN I TRY THE BOOST CONTROLLER LINE FOR THE VACUM SOURCE WILL THAT WORK. AND WHAT IS THAT NUT ON THE BACK DO YOU ADJUST THIS...MY BOOST GAUGE DOESNT HAVE A RUBBER HOSE ON IT PLASTIC LINE..... ALSO IM ONLY BOOSTING 6 PSI IN 5TH GEAR BUT ITS AT 10 PSI IN 1ST 2ND 3RD 4TH GEARS BUT 5TH IS AT 6 SPOOLS VERY SLOW TOO IN 4TH AND 5TH DOESNT SEEM RIGHT...OK I APPRECIATE THE HELP THANKS

[soundbombing]

No prob. The boost controller line will work fine. My wastegate, bov, boost gauge, boost controller, and fcd are all on the same line. I haven't had any problems at all yet. Your problem sounds like the bov but let us know. Later.

[ZMN BY U]

I have a stock bov you think i might have a problem with it? what could it be is it stuck or what it works just fine sounds like it always has just wont spool up in 5th gear before it would spool very fast in 5th but now it just stays at 6 psi when full throttle at 4000 rpms....