PDA

View Full Version : to the shop again



michiganspeed
10-21-2003, 10:20 PM
First, I have a small chip in the hood by the drivers side headlight, which is actually starting to RUST!!

Second, I must have been doing some fancy footwork, because i ripped the clip and the stud that holds the mat in place out of the floor.:wtf:

I have had it in to be flashed and to have the sub replaced(that took 2 visits).

I've got the "clunk" but i don't know if they should fix that yet. I think i read somewhere there was going to be a new fix for that. Is there any truth to that?:confused:

BlkZoomZoom
10-21-2003, 10:33 PM
New bushings........I would get the "clunk" taken care of, they'll wear out eventually anyways.
Thats all you have had replaced???? Your lucky!!
So far I had to replace on my mazdaspeed:
-3 radio headunits (that's right i'm on the 4th. one)
-1 sub/amp unit
-1 alarm control unit (hit the locks on keyless remote and parking lights would flash then stay on)
-1 wire (behind dash board pulled out of fuse panel and shorted)
-1 instrument cluster (broken wire shorted instrument cluster)
-1 swaybar links/bar and bushing (clunk, clunk, clunk)
-1 coolant hose (sepage out of connection)
-1 wheel (i swear it was bent before....)