jred321
08-02-2003, 08:03 PM
ported 16g w/ 34mm flapper, joep mbc, evo IIImanifold, 2g o2 housing (not installed), act 2600 w/ street disk, pioneer head unit, 2 infinity 12's w/ cadence 9000 amp, greddy weighted shift knob, autometer ultra lite boost and a/f gauges in autometer pod
recent timing belt, water pump, alternator, cam seals, clutch master/slave/lines, valve cover gaskets, tranny w/ 70k on it shifts perfect, radiator replaced w/ newer used one,
green exterior in good shape, not perfect but decent
tan interior in good shape
i will be replacing the valve cover before selling but as of right now it is cracked, runs fine though, oil pressure is inconsistent sometimes but never gets beyond acceptable range.
driver side lock cannot be opened from the outside for some reason, never took the time to find out, driver side headlight is stuck up, also never took the time to find out why.
i was building this car to last me for a few years (obviously from a lot of the maintenance work done) and bought it ~4 months ago, but i finally convinced my dad that i could afford the payments on a new car so this one must go. it needs suspension and motor mounts as they are worn. i have spent over 4000 since i bought the car a few months ago, but am willing to let it go for 2000.
everything has been done withing the last ~3000 miles, before i got it it was 100% stock with leaking gaskets, bad tranny, etc... e-mail me at jck15243@wpi.edu for more info, etc...
recent timing belt, water pump, alternator, cam seals, clutch master/slave/lines, valve cover gaskets, tranny w/ 70k on it shifts perfect, radiator replaced w/ newer used one,
green exterior in good shape, not perfect but decent
tan interior in good shape
i will be replacing the valve cover before selling but as of right now it is cracked, runs fine though, oil pressure is inconsistent sometimes but never gets beyond acceptable range.
driver side lock cannot be opened from the outside for some reason, never took the time to find out, driver side headlight is stuck up, also never took the time to find out why.
i was building this car to last me for a few years (obviously from a lot of the maintenance work done) and bought it ~4 months ago, but i finally convinced my dad that i could afford the payments on a new car so this one must go. it needs suspension and motor mounts as they are worn. i have spent over 4000 since i bought the car a few months ago, but am willing to let it go for 2000.
everything has been done withing the last ~3000 miles, before i got it it was 100% stock with leaking gaskets, bad tranny, etc... e-mail me at jck15243@wpi.edu for more info, etc...