Replacing rear brake caliper

[prof15]

Hey guys I am in the middle of replacing my driver side rear brake caliper. The question that I have is due to the fact that there is only on bolt/slide pin in the caliper and the other slide pin is covered..

Once I loosen the first slide pin should the other one just slide back since it doesn't have any bolts by just pushing it back or there is something I have to do?

I have the service manual but it doesn't explain how to remove it once you loosen the first slide pin. And the all the how to in the forum are for the calipers that have two slide pins instead of one..


Thanks in advance..

[prof15]

Ok.. never mind I was able to remove it.. I guess that was the original brake caliper or it was never lube in a long time.

[Diehonda]

Lube the pins. They can get stuck easily.