headers????

[jr_1086]

how difficult is it to replace the stock protege exhaust manifold for some obx headers???

[Dparks7]

not too bad...just getting the bolts off can be a pain without an air tool

[StealthWyvern]

Depends on where your at really. If you are in an area that gets rust it can be pretty bad. However its straight forward for a header... not to sure how your going to get headers on the car personally.

[jr_1086]

well im in chicago so im sure theres a decent amount of rust...im sorry what do u mean how am i gonna get headers on there...sorry im kinda new to this

[StealthWyvern]

well im in chicago so im sure theres a decent amount of rust...im sorry what do u mean how am i gonna get headers on there...sorry im kinda new to this

I'm just busting your balls a little! lol When you say headers you implying installing more then one... you can only put one on a 4 banger.

[jr_1086]

lol my b i was a little slow catching that one

[jr_1086]

what tools would i need for this job

[StealthWyvern]

what tools would i need for this job

Just a basic tool set. An 02 sensor socket def helps

[Dparks7]

and if you can air tools

[eszoom]

and if you can air tools

if no can, wd40 is a must. a 2 pc header also helps.

[Patio]

I did it with regular tools and a lift, HOWEVER the biggest pain in the ASS was getting the EGR to line up properly. Holy hell did that suck.

[jr_1086]

well i finally got the header on lol i used basic tools also and some awesome pb blaster and it was hard to get that egr pipe lined up but after an hour it was on