PDA

View Full Version : mazda6 logo removal


Katze
05-08-2009, 09:49 PM
i recently applied the atenza logo on my car but it looks weird with both logos is there a way to get the mazda6 logo off or just the 6 part preferably lol im sure there is
Atreyu3388
05-08-2009, 10:44 PM
(boom08)Oh boy...Yeah. (COUGH noob COUGH)

First purchase some sort of low intensity adhesive remover. (I use "Oops! Adhesive Removal.") Then simply pry off the Badge with a flat head screw driver WRAPPED IN CLOTH OR 2 SHEETS OF PAPER TOWEL. Then use your recently acquired adhesive remover to get the sticky residue off. And you're done.

Post if you have any trouble (lol I had to...)
bgibb68
05-08-2009, 10:45 PM
a hairdryer and fishing line works good too
Katze
05-08-2009, 10:46 PM
lol i know im a noob but thanks haha
Atreyu3388
05-08-2009, 10:50 PM
a hairdryer and fishing line works good too

+1 to this. I just prefer the quick and ruthless method (lick)
bgibb68
05-08-2009, 10:54 PM
+1 to this. I just prefer the quick and ruthless method (lick)

licking it off?? wait....that sounds kinda......ummm well.......yeah
Super Shredder
05-08-2009, 10:54 PM
a guitar e string will take it off in one swoop, and the ahesive will peel off if any is left, googone will also ensure this.
Atreyu3388
05-08-2009, 10:55 PM
a guitar e string will take it off in one swoop, and the ahesive will peel off if any is left, googone will also ensure this.

ROCK ON WITH THE MUSICAL REFERENCE!!! Musicians FTW!
Katze
05-08-2009, 11:11 PM
and there will be no permanent marks right after i take it off
bgibb68
05-08-2009, 11:12 PM
well if the badges are like the ones on the p5....there are 2 holes for pegs on the badges
Katze
05-08-2009, 11:17 PM
well i wouldnt want that. lol i might just keep it there
crlsnlopes
05-09-2009, 12:40 AM
well i wouldnt want that. lol i might just keep it there

the mazda6 logo is there with adhesive, but the flying M has two holes in it. yea and just use a fishing string this way you wont cause any damadge to the paint
Katze
05-09-2009, 12:55 AM
ok. if its adhesive ill remove it. it looks redundant when it says mazda 6 atenza lol
tunersteve
05-09-2009, 01:25 AM
The only emblem that has pins on it is the M logo at the top center of the trunk. The Mazda6 logo is all adhesive. Fishing line and heat, or a plastic putty knife do quick work, followed by lighter fluid, Goo gone, then some clay bar action. After that, you'll never notice where the badge used to be.
zinger002
05-09-2009, 03:08 PM
The only emblem that has pins on it is the M logo at the top center of the trunk. The Mazda6 logo is all adhesive. Fishing line and heat, or a plastic putty knife do quick work, followed by lighter fluid, Goo gone, then some clay bar action. After that, you'll never notice where the badge used to be.

unless you already have massive paint fade action going on. (sun)