View Full Version : What Happend to my car!
Sheadensp5
05-07-2009, 12:20 AM
Alright so im driving with my buddy in my 2002 mazda p5 and all of a sudden i lost some power i thought no big deal.. i continueed driving. it ISNT burning oil but now it makes a bang cracking noise and sometimes a whine... im thinking a bearing. any suggestions... flattened valve? stilll runs but very shitty thanks ffor your help
Mike R
05-07-2009, 06:33 PM
pull the plugs and see how they look.
Sheadensp5
05-08-2009, 01:00 AM
so any ideas lol or should i just pay the 4 grand to get a mech to look at it haha . i pulled the plugs and they look fine its not burning oil and it seems to have roughly the same compression... the sound seems to be coming from the 4th cylinder... rod?
aMaff
05-08-2009, 01:04 AM
any way you can take a video of the noise? Rod knock is pretty easily discernible, however I'd be very surprised for an N/A, Auto P5 that doesn't get seriously ragged on to ever do that unless it was run low on oil...
Does it do it all the time, just at idle, just at cruise, just on accel or decel?
aMaff
05-08-2009, 01:06 AM
I cleaned the thread up. What say we try to keep this on topic and get this guy back on the road, ok kids? ;)
PS: (admin)
Sheadensp5
05-08-2009, 01:09 AM
its all the time and it is a constant knock and sometimes a whine
rdane
05-08-2009, 02:07 AM
check the spark plugs... or better replace it...
Sheadensp5
05-12-2009, 02:03 PM
so i checked the plugs its al;l good. doesnt burn oil or anything just a loud bang... i think its a rod bearing does that mean new motor. the second it made the noise i shut it off.... any ideas
LinuxRacr
05-12-2009, 02:45 PM
I wonder if it is one of your VICS screws coming loose? Also check your plug wires.
Sheadensp5
05-13-2009, 12:31 AM
no i dont think a screw could do that its loud as hell
Rut Ro
05-13-2009, 12:48 AM
When you say "it seems to have roughly the same compression..." does that mean you did a compression test? Loud knock or tick? Is the sound coming from the upper part or lower part of the motor? Just trying to eliminate various parts that could be causing the issue here for ya. Sorry for the twenty questions.
Sheadensp5
05-15-2009, 02:27 AM
no i just put my hand over the empty spark plug hole and they all felt the same when i cranked it over... it seems to be coming from the passenger side i beilieve rthe 4th piston... its right by the timing belt
i12drivemyMP5
05-15-2009, 08:00 AM
If it's by the timing belt, that'd be #1 piston. Drive it til it blows or start taking stuff apart until you find it or just take it somewhere & have someone tell you what it is. It will not fix itself or just go away. From the description, it sounds terminal. Spark plugs or wires won't fix it & doesn't sound like VICS screws.
Sheadensp5
05-20-2009, 12:56 PM
i no it wont fo away lol but how much would a race- type engine be for this car like my buddy has an 89 prelude with a aftermarket 4 cyl and a chip ( no turbo) and it eats srt 4s for breakfast... i want somethin like that outta my mazda
Viralphrame
05-20-2009, 01:00 PM
i no it wont fo away lol but how much would a race- type engine be for this car like my buddy has an 89 prelude with a aftermarket 4 cyl and a chip ( no turbo) and it eats srt 4s for breakfast... i want somethin like that outta my mazda
A 'race-type' engine. Lol.
Unless you have extremely deep pockets, you will be putting the same FS-DE motor into your P5 that you have in there right now. There isn't much available in terms of engine swaps. If you have slightly deep pockets, you can easily buy a built FS-DE motor (forged rods, pistons, etc.) from a vendor like SpeedCircuit for $3000-4000 dollars.
ucMP3
05-20-2009, 01:01 PM
i no it wont fo away lol but how much would a race- type engine be for this car like my buddy has an 89 prelude with a aftermarket 4 cyl and a chip ( no turbo) and it eats srt 4s for breakfast... i want somethin like that outta my mazda
LOL Good luck.... (thumb)
Sheadensp5
05-20-2009, 06:54 PM
will that 3 -4 thousand dollar engine amp up the ponies alot? i just dont wanna waste the money on it if it isnt worth it
Sheadensp5
05-27-2009, 07:48 PM
so took oil pan off.... millin shards of metal in the bottom haha new motor
Powered by vBulletin® Version 4.1.7 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.