A/F gauge install problems

[zuku26]

I just installed my Stewart warner narrow band A/F gauge like the How to says. and the light is just staying green all the way without moving. just the last green light stays on??
I ran the
Source wire to the pink and blue wire at the 1st O2 sensor
Ground to a bolt that looks to be holding a relay just in front of the fuse box located by the drivers door
12v power to the black with white stripe wire located at the steering colomn
What did I do wrong here??
Or is the car actually running that rich the whole time??

[NRRfrogmanP5]

did u try driving it yet?

[zuku26]

Yeah Matt,
I drove around the block a few times, no change. I went into boost, ect no change???
I can't figure it out. I'm guessing it was the Ground or 12v source, I'd just have no power right?

Congrats on today's game by the way.

[NRRfrogmanP5]

it could be the ground maybe cause if its powered it would light up but maybe if the ground is bad it wont be able to properly function. shoot a pm to bryan or wilson. bryan did mine and well if u seen wilsons car lately i think he would know about this..

and yeah thanks now lets hope the other team is red can pull out a victory tonite

[haveahotcarl]

I think your signal wire is not getting any voltage from the sensor. I tested an AutoMeter narrow band from my Festiva by just hooking it up to a power source without the signal wire connected to anything. I got the same thing you are, last green light indicating rich was lit. I would check the splice you made into the wire to see if it is really working or if it is the right wire you spliced into. Hope that helps.

[zuku26]

Thanks for the help guys!!
I removed the Source wire from the gauge itself, then turned on the car to see what it read. It stayed dead center. Then I shut the car down and reconnected that wire to the gauge, and it started working!!!

[NRRfrogmanP5]

yay!