View Full Version : Check Engine Light After Intake Install Help!!!
brooklynspeed3
02-24-2009, 11:01 AM
hi can anyone help me with my issue. i installed my cai and i followed the steps verbatum. (hope i spelled it right lol) and 8 hours after the install i get a check engine light do i have to take the battery terminal off again so the ecu can reset once more. does this go away or what??????
AutoEuphoria
02-24-2009, 11:10 AM
Disconnect the battery and press the brake pedal for like 15 seconds...then connect the battery again. If it's still there, try finding someplace that will read the code. There's not much we can do to help without knowing which code is being thrown. Do you have a DashHawk?
speed3driver
02-24-2009, 11:10 AM
Did you scan the car to see what the CEL was thrown up for? You can check it with an AP, a dashhawk, or at autozone for free.
mazdasp33d
02-24-2009, 11:18 AM
8 hours to instal a cai??
AutoEuphoria
02-24-2009, 11:24 AM
I could see that if you weren't really confident in your skills and had to take the front bumper off. But yeah, that seems a bit steep even then I guess.
In any case, try disconnecting the battery for a little while and if that does not fix the issue find a way to pull the CEL code.
Hank3
02-24-2009, 11:35 AM
Doesn't necessarily mean it took him 8 hours to install it - well at least I hope not. It just says 8 hours after he installed it :)
Sport6
02-24-2009, 11:47 AM
It would also help if we knew what CAI you installed.
Make sure you have tightened down all the clamps and make sure the MAF sensor is down tight and the connector is all the way in.
brooklynspeed3
02-24-2009, 07:48 PM
8 hours to instal a cai??
NO SMART ASSS 8 hours after i installed and drove it around!!
brooklynspeed3
02-24-2009, 07:51 PM
I could see that if you weren't really confident in your skills and had to take the front bumper off. But yeah, that seems a bit steep even then I guess.
In any case, try disconnecting the battery for a little while and if that does not fix the issue find a way to pull the CEL code.
wut the hell you talkin about confidence in work!! i said nothing about bumpers or anything!! you dont know how i installed it.
You didn't answer this. This is the only thing that can help us help you.
Did you scan the car to see what the CEL was thrown up for?
brooklynspeed3
02-24-2009, 08:12 PM
You didn't answer this. This is the only thing that can help us help you.
no not yet i had to go to my daughters school today. a kid bit her so she punched him in his face and made him bleed out his nose. lol but ill get it checked tomorrow!
AutoEuphoria
02-25-2009, 12:03 AM
I went from the stock airbox to the CP-E cold air intake and got a CEL as soon as I started the car. Used the dashhawk to read the code...IAT sensor. I cleared the code, started the car again, and everything was fine.
Powered by vBulletin® Version 4.1.7 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.